Hello
Can anybody help or advise?
We have a Bridgeport VMC 1000 with a Heidenhain TNC 370 Controller.
After running a program, the spindle had returned to M25 position for a few minutes and then an error appeared: AXIS DRIVE FAULT
After checking the obvious with the electrician, it was determined that power is reaching the main server drive (Siemens), but the axis drives are not turning on. Occasionally, while testing, the lights on the axis drives flicked on, but then turned off again within seconds.
Any thoughts on this?
Many thanks for your help.
Can anybody help or advise?
We have a Bridgeport VMC 1000 with a Heidenhain TNC 370 Controller.
After running a program, the spindle had returned to M25 position for a few minutes and then an error appeared: AXIS DRIVE FAULT
After checking the obvious with the electrician, it was determined that power is reaching the main server drive (Siemens), but the axis drives are not turning on. Occasionally, while testing, the lights on the axis drives flicked on, but then turned off again within seconds.
Any thoughts on this?
Many thanks for your help.