Greetings.
My names Matt and I am a new apprentice in a machine shop. I have been given the task of working on a few of the Hardinge HLV-V lathes that need some repair. The high/low lever is not engaging in the neutral position. So when I go from running at high speed and attempt to stop the motor if I am not careful it will switch over into the low position. I was wondering if there was some type of detent or assembly that needs tweaking or replacing.
any help is greatly appreciated.
Thanks,
Matt
My names Matt and I am a new apprentice in a machine shop. I have been given the task of working on a few of the Hardinge HLV-V lathes that need some repair. The high/low lever is not engaging in the neutral position. So when I go from running at high speed and attempt to stop the motor if I am not careful it will switch over into the low position. I was wondering if there was some type of detent or assembly that needs tweaking or replacing.
any help is greatly appreciated.
Thanks,
Matt