1996 EZ TRAK DX, 2 axis:
Just got the machine in place and wired up and was checking everything out. It's been idle about 8 months since I purchased it.
Here's one issue: When moving the quill and returning to the stop, the Z axis readout doesn't return to it's original (shown) position.
Not only that but each successive time I move the quill away and back to the stop, the readout gains about 0.02. The .02 is not consistent but it's in that range.
Tried re-zeroing, to no avail.
The mount hardware all seems tight.
I've not yet peered behind the rubber seals, for fear of more contamination.
Is it DOA or .......?
thx
waddell
Just got the machine in place and wired up and was checking everything out. It's been idle about 8 months since I purchased it.
Here's one issue: When moving the quill and returning to the stop, the Z axis readout doesn't return to it's original (shown) position.
Not only that but each successive time I move the quill away and back to the stop, the readout gains about 0.02. The .02 is not consistent but it's in that range.
Tried re-zeroing, to no avail.
The mount hardware all seems tight.
I've not yet peered behind the rubber seals, for fear of more contamination.
Is it DOA or .......?
thx
waddell