Hi to everyone,
I have a problem with my Erskine 6F power feed pcb fitted to my Bridgeport apparently its an early version that does not have much in the way of components on the pcb, but I have 2 burnt out resistors due to the micro switches going bad.
What I am hoping is that someone out there has the same looking Erskine version as me and perhaps they would not mind looking at there pcb to let me know the value of my burnt out resistors.
If any one recognises this photo perhaps they could pm me or reply on here.
The Bridgeport is made by Adcock and Shipley Uk and the Controller is Erskine ISSUE 3 PD/1022/02/F/A2
but its easier to look at the photo.
Thanks to all in advance.
Regards
Richard..![Click image for larger version.
Name: Erskine controller.jpg
Views: 38
Size: 82.0 KB
ID: 108411]()
I have a problem with my Erskine 6F power feed pcb fitted to my Bridgeport apparently its an early version that does not have much in the way of components on the pcb, but I have 2 burnt out resistors due to the micro switches going bad.
What I am hoping is that someone out there has the same looking Erskine version as me and perhaps they would not mind looking at there pcb to let me know the value of my burnt out resistors.
If any one recognises this photo perhaps they could pm me or reply on here.
The Bridgeport is made by Adcock and Shipley Uk and the Controller is Erskine ISSUE 3 PD/1022/02/F/A2
but its easier to look at the photo.
Thanks to all in advance.
Regards
Richard..
