Hi Everybody,
I disassembled my Bridgeport by removing the table, saddle and cleaning its wounded knee. I looked everything over and yes since I removed the y gib after removing the table I didn't notice the drilled out y gib adjustment screw. Now I am fuming mad because the lack of this screw will most certainly get in my way of putting it all back together and getting off the ground. If there is anyone out there who knows the drill and tap size combination so I can recreate the hole in a slightly different position that would be great otherwise I am screwed and cant find that information anywhere as of yet.
Sincerely,
Machinetoolshop
I disassembled my Bridgeport by removing the table, saddle and cleaning its wounded knee. I looked everything over and yes since I removed the y gib after removing the table I didn't notice the drilled out y gib adjustment screw. Now I am fuming mad because the lack of this screw will most certainly get in my way of putting it all back together and getting off the ground. If there is anyone out there who knows the drill and tap size combination so I can recreate the hole in a slightly different position that would be great otherwise I am screwed and cant find that information anywhere as of yet.
Sincerely,
Machinetoolshop