Hi everyone. I want to get a multifix-style toolpost and am trying to size up the proper shank sizes for my new HLV.
The SPi catalog says that, for A-size toolposts, the min height between top of compound and spindle center is 1 1/8". This assumes a 3/4" shank tool.
The HLV spindle center height is just a hair over 1". So with a 5/8" shank, that's exactly at the limit of the spec if not a hair past it. With a 1/2" shank, there's some clearance.
Does anyone have experience with the holders to say if the 5/8" is too big? I don't have any 1/2" tools and would like to order some before my toolpost gets here, if needed.
Thanks!
The SPi catalog says that, for A-size toolposts, the min height between top of compound and spindle center is 1 1/8". This assumes a 3/4" shank tool.
The HLV spindle center height is just a hair over 1". So with a 5/8" shank, that's exactly at the limit of the spec if not a hair past it. With a 1/2" shank, there's some clearance.
Does anyone have experience with the holders to say if the 5/8" is too big? I don't have any 1/2" tools and would like to order some before my toolpost gets here, if needed.
Thanks!