Experienced a major fault with the TNC145 Interact. Powered the machine up after a few weeks sitting idle, for some reason when i pushed the power on button the z axis started moving downwards until it hit the limit. I tried to reset the system but couldn't get it to run through the initial axis setup. Opened the control panel and smoke met me. The Z15 control board to the far right had blew up. Has anyone had this issue? I am putting it down to damp winter conditions in my workshop. Plans for a new insulated and heated workshop are now a must. Has anyone came across a cheap way of heating their workshops by PV panels or ground source heat pumps etc?
↧